Direct conversion of ethane to acetic acid over H-ZSM-5 using H2O2 in aqueous phase

Authors: Abul Kalam Md. Lutfor Rahman, Rie Indo, Hidehisa Hagiwara, Tatsumi Ishihara

Abstract:
Partial oxidation of ethane on protonated pentasil-type zeolite (H-ZSM-5) was studied by using hydrogen peroxide (H₂O₂), an environment friendly oxidizing agent. Acetic acid (CH₃COOH) and formic acid (HCOOH) were obtained with high yield and selectivity from ethane. In addition, the influence of reaction parameters such as temperature, pressure, amount of oxidizing agent, and reaction period was investigated. Yields of acetic acid and formic acid (based on ethane) were achieved up to values of 18.7% and 14%, respectively, under the optimized reaction condition of 393K and 3.0 MPa. Selectivity to both compounds is 84% under this condition. The amount of oxidant(H₂O₂) was optimized to be 279 mmol for the reaction. A low silica to alumina ratio in H-ZSM-5 was favorable for the partial oxidation of ethane. CO₂ formation was observed as a deep oxidation product at initial period. Partial oxidation was observed to occur within a short reaction period and was associated with the active oxygen species produced from H₂O₂ and CO₂ formed through the deep oxidation of ethane. Since the yield of CH₃COOH from ethane is much higher than that from ethylene, partial oxidation on H-ZSM-5 proceeds through a reaction mechanism different from that of a Wacker-type oxidation reaction.

Keywords:
Acetic acid
Liquid phase oxidation
Ethane
H-ZSM-5

Published in: Applied catalysis A: General  (Volume 456, Pages 1-248, 10 April 2013)

Publisher: Elsevier

ISSN Information: 0926-860X

Direct conversion of ethane to acetic acid over H-ZSM-5 using H2O2 in aqueous phase

Bình luận của bạn

*

*

*

*

 Captcha

Gửi bình luận nhập lại